ACCESSORIES Stainless Steel Dirt Trap
Configure your mat
Item number SWEohne
The stainless steel dirt trap as a substructure for mats and gratings. For indoor and outdoor use. Precisely made to measure in width and length. Optional: With water drainage at no extra charge. For mats in 22 mm height and gratings in 25 mm height. Made to measure: If both dimensions (length and width) exceed 135 cm, the tub is made of several parts. Please contact us for information on your dimensions.
Stainless steel dirt trap for entrance mats and gratings
For less maintenance under aluminum profile mats and the possibility of water drainage, you can install the stainless steel dirt trap as a substructure under aluminum profile mats. The stainless steel dirt trap is made to your exact measurements and can be used inside as well as outside buildings.
As an option, you can install a water drain with the stainless steel dirt trap. With the stainless steel dirt trap you can choose at which position a water drain is installed. From the water drain, in turn, pipes must be planned for connection to the sewer system.
You can design large areas with the stainless steel dirt trap. We can produce the stainless steel dirt trap in almost any dimensions.
The stainless steel dirt trap has an installation height of 80 mm and square tubes (30x30x3 mm) are inserted at regular intervals of approx. 30 cm in the running direction for the purpose of secure support of the aluminum profile mats.
Installation of the stainless steel dirt trap for entrance mats and gratings
Normally you will receive the stainless steel dirt trap directly assembled.
Place the assembled stainless steel dirt trap in the recessed screed or floor covering. Make sure that the upper edge of the frame is flush with the floor covering. The bed on which the dirt trap rests should have been prepared beforehand and must be absolutely flat and even so that the stainless steel dirt trap rests properly.
Special features of the stainless steel dirt collector:
- The mat support bars in the tray are designed so that they do not obstruct the water drainage.
- Water drainage devices with sieve can be mounted at any point.
-Large areas are covered with several tubs.
- There are no limits to individual design possibilities with these tubs.
Technical data of the ACCESSORIES stainless steel dirt trap:
Material 100 % stainless steel
Installation height
approx. 7,5 cm
Corners:
Corners are welded at the factory
Bottom:
Comes with custom-fit stainless steel plates for the bottom of the debris tray Additionally, welded-in support bars are recessed into the tray approximately every 30 cm
Other available tubs Tub is also available in aluminum
Dimensions:
Recesses, curves and slopes according to sketches, drawings or templates are possible
Larger areas are composed of several tubs.
Capacity: Suitable for all types of foot traffic
Gewicht netto: 27500 g